Second layer, and some doubts

[dacdri]

After applying the first layer of CQ 3.0 uk, can I apply a second layer after three hours?
Or do I have to apply the second coat, at most an hour later?
I don't know if I will have enough time to apply, the second coat after an hour so my doubts.
After the second layer, do I apply the Reload one hour later or the next day correct?
Thank you

[The Guz]

From the product page

https://www.carpro-us.com/protection/cquartz-uk-3-0-30ml-kit/

Read "Tips" above before coating


Wrap a 4" Microfiber Suede around the black side of applicator block.
Shake CQuartz UK.
Slowly open bottle and drag one or two lines of product down the applicator.
Spread across paint in a criss cross pattern approximately 2 sq ft at a time depending on conditions.
Buff off as soon as it flashes (within 2-5 minutes depending - see tips above) using a CarPro No Lint Ultra Towel 16" x 16".
Be sure to remove all excess residue and only then do you move to the next section.
Switch out the 4" Suedes every 2+/- panels.
Additional coats may be applied within 45-60 minutes or wait until the following day if you are beyond 60 minutes. CarPro recommends 2 coats. Max Layer - 3 coats.
Apply Reload after final coat within 30-60 mins. Wait until next day for Reload if you miss the 30-60 minute window or at least a minimum of 12 hrs.

[dacdri]

Thank you for the informations.
If I am going to apply the second layer the next day, can I use Eraser before, on the first layer to proceed with the second layer? thank you.

[The Guz]

No don’t use eraser. That could impact the first layer. Take a plush towel and lightly and drag it to let the towel pick up the dust.

You could try a damp towel as well.

[dacdri]

No don’t use eraser. That could impact the first layer. Take a plush towel and lightly and drag it to let the towel pick up the dust.

You could try a damp towel as well.
Ok thank you very much for the information.