Hi Folks,
Looking to replace my P.C. 7424, which handles my 3"-4" pads for small areas. Wondering if any of you use the Rupes 75 mini and your thoughts...
FYI...I use the Flex 3401 for 5"-6" pads.
Thanks,
Steve
Hi Folks,
Looking to replace my P.C. 7424, which handles my 3"-4" pads for small areas. Wondering if any of you use the Rupes 75 mini and your thoughts...
FYI...I use the Flex 3401 for 5"-6" pads.
Thanks,
Steve
I just picked one up a couple months ago. I had been using the pneumatic one for quite a while but was tired of listening to my compressor run. I think the pneumatic one cuts a little better but the mini is still a great tool and it's my new go to for tighter areas. I would get the Metabo backing plate for it though.
I have the mini and use it all the time. I use it for 3" and 4" pads, and would say it is up there with one of the best tools I bought this year. If you like your 15 or 21, you will love the mini.
I have the mini and love it. Very powerful. Use it flash pad and Scholl pads.
Sent from my iPhone using Tapatalk
I want one of those
https://www.facebook.com/FlawlessFinishDetailing
Dr. Claude Tremblay, Co-owner/Senior Detailer, Certified CQuartz Finest Installer
How much better is it than the Porter Cable?
What are the key differences?