Hologramss after second coat, already applied Gliss

[nem3]

Hello all, first post here, also first time user of ceramic coatings. Did the full decon, prep and polishing. First coat of CQuartz UK 3.0 went on perfect. Coating time ended up taking me just shy of two hours so waited until the next day to apply the second coating. Ended up being cloudy today, so was able to pull the car out and check for issues, no dark/high spots. Everything looked very good (first coating, not so much). So pulled back in and waited the four hours to apply Gliss. Was later in the day, so I got about half the car done before I had to break out extra lighting. That's when I noticed the glaring problem, holograms EVERYWHERE. From what I can tell, due to temp/humidity today, I likely did not properly level out the second coat of CQuartz UK. My issue now is next steps.... Is my best course of action to remove Gliss and attempt to polish out CQuartz UK? If so, how do I go about doing that? Or perhaps any other suggestions?

Door
IMG_3927_2.jpg

Trunk
IMG_3928_2.jpg