Originally Posted by
hvdcman
Coated our truck following the usual regimen, wash, Iron-x, clay bar, swirl remover, polish, and finally CQuartz 3.0.
The coating was applied indoors, With 2 coats applied. When I last washed the truck, it was outside undercover, and
I noticed some faint water spots on one side of the bed, where dog rides and slobbers on occasionally.
I attempt to wipe down the sides after every dog ride.
Essence was suggested, and I tried a little bit by hand on the spots with no success.
Would I be better off repolishing the area completely, verify spots are gone then recoat? Or is there another way to attack this?
The spots only show up in bright light if the angle is just right. Any help is greatly appreciated.