CQuartz additional layers

  • Thread starter Thread starter Drewvipers
  • Start date Start date
D

Drewvipers

Guest
Can I apply a second and third coat of Cquartz be applied 5 days after first coat?
 
Which one did you use...Uk, or TiO2?

Taken from TiO2 product page...
5. Additional coats may be applied with 45-60 minutes or wait until the following day if you are beyond 60 minutes. CarPro recommends 2 coats

Also take from product page...
After Tips:

Keep surface dry for at least one hour after application
Wipe any water off the surface during the first 24 hours after application
Avoid washing with soap for the first 5 days
 
I used TiO2... I saw that on the website. The question is how can I go about applying the 2nd and 3rd layers after 5 days. Can I just do a cleaning and laying on top?
 
I would say it depends on the environment your car was in. A wash may be just fine then layer. If your car was in an area that was exposed to fallout, rail yards, industrial area, long travel time, I would wait so you can treat with Iron X to ensure a good clean surface.
 

I added additional layers after 2 years. I didn't need to polish and I was adding CQUK over top of the CQ org.

I did a wash, chemical decon, and a full wipe down with Eraser. Then I simply applied the CQUK. Everything worked well and CQUK has been on for over 3 years.

I would guess since it has only been 1 week you could wash and a full wipe down with Eraser then add additional coats.
 
That would work. I was just afraid of the new layers not sticking in... thanks for the help guys.
 
You must log in or register to reply here.
Back
Top