I'm doing my research on how to apply CQ UK 3.0 to the entire vehicle, and figured out that I definitely need some good help.
1. Most Youtube videos only show how to coat half of the hood or a door, but I wonder how you would section a whole car? I tried to make the following sectioning:
I don't think I can do the complete hood/roof at once, so I split them into two sections each. But I can probably do the trunk lid in one run. Still I feel like I may have too many sections to work on, I don't want to go over 1 hr after finishing a complete layer, any suggestions?
2. Do I need to avoid the chrome-plastic trim and lights? (I actually do want to coat them too, if possible)
3. I may have to do the coating outdoors (which surely isn't the best practice). If I want to apply a second layer, and then reload after the second later, and dust falls on the paint during the 1 hr curing time, how can I remove the dust safely in order to proceed?
Thanks!
1. Most Youtube videos only show how to coat half of the hood or a door, but I wonder how you would section a whole car? I tried to make the following sectioning:
I don't think I can do the complete hood/roof at once, so I split them into two sections each. But I can probably do the trunk lid in one run. Still I feel like I may have too many sections to work on, I don't want to go over 1 hr after finishing a complete layer, any suggestions?
2. Do I need to avoid the chrome-plastic trim and lights? (I actually do want to coat them too, if possible)
3. I may have to do the coating outdoors (which surely isn't the best practice). If I want to apply a second layer, and then reload after the second later, and dust falls on the paint during the 1 hr curing time, how can I remove the dust safely in order to proceed?
Thanks!