Layering C-Quartz

B

bobgiles87

New member
Hello all.

I have Cquartz 3.0 UK coated on my vehicle (it doesnt get driven in winter, is stored - was applied in sept last year)

I am planning on layering it with Gliss next spring, car has some minor light scuffs from car cover.

I plan on:

Essence PLUS -> Eraser -> Gliss

Any other suggestions?

Also - thoughts on using Hydrosuds by CG over the coating for a wash vs Reset?
 
It is not recommended to layer over Essence Plus. I am not 100 percent certain that Eraser will remove the SiO2 left behind by Essence Plus.

Q. Can I use Essence PLUS underneath CQuartz like I did with Essence?

A. No, this is not a primer like Essence is and coatings will not bond on top! If used inconjunction with a coating, this goes on TOP, not bottom.


You could try it and see if it works.
 
Going to apply small amount of Essence+ with Red CG pad to only affected areas, wipe out with Eraser, then coat car with Gliss.. Ill keep you guys posted
 
You must log in or register to reply here.
Back
Top