Re-Application of CQuartz UK

Mark

Mark

New member
Forgive me if this has previously been asked here.

My one vehicle has been once coated with CQUK about 1-1/2 years ago, and since, has only been detailed with CQ Reload a few times. No other products used.

As far as I can see, my paint needs no correction again with Polishes, but would like applying another layer of CQUK.

Could a good paint cleanser such as either Pinnacle, or DP from AG be used to good effect? I would hope that by some method, I wouldn't necessarily have to remove what CQUK is already on the paint, yet be able to prep the paint for proper bonding without streaking, faulty bond issues, etc issues with another coat?

I have Eraser on hand, but am gathering Eraser by itself would not prove effective.

Can what I would like to do be done? Or do I then have to go at it again with DA, Polishes, the whole nine yards again?

I was hoping for just a simple hand application of a paint cleanser, simple, fairly fast.

Has anyone ever done this with success?

TIA, Mark
 
Hi Mark! Sorry for late reply. You COULD use Four Star Paint Cleanser on machine followed by eraser and have a good shot at it but at that point you might as well be sure and simply hit it one fast pass with reflect. Then eraser
 

I actually have done exactly what you are looking for.

I did an IronX application then I spot clayed and used TarX where needed. Then I did a full wash with IronX soap and Reset mixed. This created the surface neede to re-coat. Then I simply did an Eraser wipe down and re-coated. It worked great.

I did CQUK over 2.5 year old CQ. And I am not any nearly 2 years on CQUK with no issues.
 
Good knowledge to know, thanks for the post everyone.

Sent from my SM-T230NU using Tapatalk
 
You must log in or register to reply here.
Back
Top